Milli-amp process clamp meter can measure mA signals without breaking the loop. Clamp meter is premier mA clamp meter providing with the best in troubleshooting and process calibration power. Best in class 0.2 % accuracy. 0.01 mA resolution and sensitivity. Measure 4 to 20 mA signals without ”breaking the loop”. Measure mA signals for PLC and control system analog input/output. Dual backlit display with both mA measurement and percent of 4 to 20 mA span. Measurement Spotlight illuminates hard to see wires in dark enclosures. Detachable clamp with extension cable for measurements in tight locations. Measure 10 to 50 mA signals in older control systems using the 99.9 mA range. Automatically change the 4 to 20 mA output for remote testing. Power saving features, auto-off, backlight timeout extend battery life. Hold function captures and displays changing measurements. Measure 4 to 20 mA signals with in-circuit measurement. Simultaneous mA in-circuit measurement with 24V loop power for powering and testing transmitters. Source 4 to 20 mA signals for testing control system I/O or I/Ps mA output linear ramp or 25% step output. Automatically change the 4 to 20 mA output for remote testing. DC voltage measurement to verify 24V power supplies or voltage I/O signals. Source DC voltage to test input devices that accept a 1 to 5V or 0 to 10 V signals. Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp. Enables milliamp signal logging to a separate logging device without breaking the loop. Output mA signal enables a logging DMM or other device to record the 4 to 20 mA signal without breaking the loop mA in/out, simultaneously measure the mA signal with the clamp and source a mA signal.